TiagoFigueiredo
Industrial
- May 22, 2013
- 501
Hello,
I know that this thread is not located in the proper section. But I know that there is a few tooling designers in this forum.
I need to look for a metal stamping simulation software.
I already know Autoform (it's so expensive!!!), more than 10 years ago, I used hyperform, and I know that there is Dynaform.
According to your experience, which one have the best ratio between cost and benefits?
Be free to name another softwares.
Tiago Figueiredo
Tooling Engineer
Youtube channel:
I know that this thread is not located in the proper section. But I know that there is a few tooling designers in this forum.
I need to look for a metal stamping simulation software.
I already know Autoform (it's so expensive!!!), more than 10 years ago, I used hyperform, and I know that there is Dynaform.
According to your experience, which one have the best ratio between cost and benefits?
Be free to name another softwares.
Tiago Figueiredo
Tooling Engineer
Youtube channel:
