Microstation 3

[Hect]

I need to convert a Microstation drawing to PDF what can i do?

 

[CADQUEEN]

THERE IS A SHARE WARE ON CADALOG.COM CALLED VIEW COMPANION.
IT TAKES ABOUT 2 MINUTES TO DOWNLOAD AND INSTALL.
IT IS WHAT I USE. VERY SIMPLE PROGRAM.
Good luck

 

[RAWeber]

I use PDF995, which is also shareware. I won't do things like embedded fonts or hyperlinks, but for 8.5x11 or 11x17 CADD drawings, it does the trick. I'm going to go check out that View Companion and see if I like it better. The PDF995 creates a driver that can be used by any program in windows that prints.

Robert Weber, EI
Maurer-Stutz, Inc

http://www.maurerstutzinc.com

http://www.geocities.com/robntweber

"I am satisfied that your answer is correct. I am not, however, satisfied that your answer is right."