jimboux
Mechanical
- Oct 3, 2011
- 12
Hi,
I'm looking to come up with a machining time estimate to mill some CS Plate (A516-70). I need to face/shoulder mill off a "1/4 moon" shape of about 104 sq. in. by 1" deep. The only shoulder milling is around a 5" radius for about 270 degrees. The rest is all face mill. If it make it easier for estimating, it the equivalent to a diameter of 11.5" fully milled down 1". This would be done on an Okuma Milliac 561V, I'm not sure of the cutter type but I think it's Sandvik Coromill 390, exact tooling is unknown. I'm not looking for an exact time, just one that will let me know if someone is blowing smoke. Thanks much.
I'm looking to come up with a machining time estimate to mill some CS Plate (A516-70). I need to face/shoulder mill off a "1/4 moon" shape of about 104 sq. in. by 1" deep. The only shoulder milling is around a 5" radius for about 270 degrees. The rest is all face mill. If it make it easier for estimating, it the equivalent to a diameter of 11.5" fully milled down 1". This would be done on an Okuma Milliac 561V, I'm not sure of the cutter type but I think it's Sandvik Coromill 390, exact tooling is unknown. I'm not looking for an exact time, just one that will let me know if someone is blowing smoke. Thanks much.