Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

More on LTSCALE & PSLTSCALE

Status
Not open for further replies.

cfee

Industrial
Apr 22, 2002
491
Setting LTSCALE to 1 & PSLTSCALE in each vport to 1, gives back a measure of line-type scale control, but I'm encountering a different (if related ) problem.

Using linetypes from our working linetype file, I'm sometimes having to set individual linetype scales in P-
space to ".05", etc. Its JUST EXACTLY as if the scales are 100 times "off". I could understand needing to do something like this in a MS viewport, where the zoomed scale is something like 1"=10' (120), bur even that should run counter to what the documentation on the variable says...
but this is in PS where everything is set relative to "1", and the border is == 11X17 & printed 1:1.

Any thoughts?

Thanks-
C.Fee
 
Replies continue below

Recommended for you

Status
Not open for further replies.

Part and Inventory Search

Sponsor