Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Motor laminations, 550Hz PM motor

Status
Not open for further replies.

trist

Electrical
Jul 26, 2002
3
NO
Hello,

My company has built two prototype 10kW PM motors with nominal frequency at 550Hz. The stator and rotor iron are built up of an 0.20 mm electrical steel sheet material(NO20). The sheets for the prototypes have been lasercut.

As we are preparing a larger number of produced units (a gradually increasing production starting with approx. 10 units), we need to focus on production cost. Therefore, I believe that lasercutting is not an option.

Any helpful tips on suitable materials and/or suitable manufacturers?

 
Replies continue below

Recommended for you

Suggestion: The laser cutting is somewhat related to the better product quality. What would be a quality criterion for the alternative?
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top