Mouse Over of Displayed components causes slow selection in NX4

[Singsonite]

Hello. Slightly embarassed to ask because I have fixed this problem many other times. For some reason, this time, the solution is not presenting itself.

Question: What setting in NX4 would cause assembly components, when moused over, to highlight every feature of the component (one feature at a time) rather than highlighting the component as a whole?

For instance: I'm in my top level assembly and I have nothing but a simple frame as a component. When I quickly mouse over the frame, the frame highlights by turning orange one line and one surface at a time until all are highlighted.

If any can point me in the right direction, I would very much appreciate it.

Thanks,

John B. Conger
Tool Design
Automotive Interiors
Advanced Engineering Solutions Inc.

http://www.advancedinternational.com/

 

[Singsonite]

Nevermind. This turned out to be a driver issue with the graphics card. Apparently Windows 7 did not have the best driver to support NX4. After downloading the latest driver from Nvidia, the problem is now fixed.

John B. Conger
Tool Design
Automotive Interiors
Advanced Engineering Solutions Inc.

http://www.advancedinternational.com/