Move spline points with Mechanical Routing

[jerry1423]

I am adjusting the spline points on a hydraulic hose using mechanical routing.
There are times when I move a knot point and the neighboring knot point moves with it, and other
times when I move a knot point and the neighboring points don't move, and that is what I prefer.
I know there is a setting that controls this, but I have no idea what it is.
Can any give me tips on moving knot points in NX Routing?

Jerry J.
UGV5-NX1899

 

[cowski]

Did you get this sorted out?
I'm not familiar with the mechanical routing application. However, I know that in the studio spline command, you can select multiple control points then click and drag on one and they all move together. This has caught me out a few times when I intended to only move one control point. Perhaps the mechanical routing works similarly and you had more than 1 control point selected?

www.nxjournaling.com

 

[jerry1423]

Yes, I think I have this all sorted out. When I logged on the next day it worked fine.
The routing spline works very much like the studio spline, so I think it's a matter of being aware of what you are doing !

Jerry J.
UGV5-NX1899