Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Multi-Plate Eccentric Cone

Thread starter PhilScrimp
Start date Nov 28, 2017

Status: Not open for further replies.

Nov 28, 2017

PhilScrimp

Mechanical

Anyone have experience with a multi-plate eccentric cone in Solidworks? This is a 16'(large opening)x 28"(small opening) x 13'10" tall. I will need multiple plates to fabricate this cone, so I was trying to determine if I could break the cone into its individual plates with break lines.

Picture attached

Thanks,

http://files.engineering.com/getfile.aspx?folder=12147b88-8862-4eb9-b368-51f7fb170c55&file=eccentric_cone.jpg