Mutisection surface with guide curve support

[AFROUZ3]

Hello everybody

It is simple to create a multisections surface with a continuity on section support. But I don't know how to create one with guide support. Can you please guide me which conditions I must take into account?

 

[TibiX]

Hello AFROUZ3,

It is not very simple to explain... but you can find the methodology for Multi-sections Surfaces here.

Also, these [box]You[COLOR=white red]Tube[/color][/box] videos might be of help:

[youtube jIWRPcZWQuY][tab][youtube C_iDtSJhVLw]​

Hope this helps,
Best of luck!

[small]
CATIA v5 — user & trainer
ANSYS — user (beginner)
[/small]

 

[AFROUZ3]

TibiX, Thank you. I am familiar enough to use multisections surface. The only thing I can't imagine is this:

Similarly, you can impose a tangency onto each guide, by selection of a surface or a plane (the direction is tangent to the plane's normal). In this case, the sections must also be tangent to the surface.

It would be a nice help if someone could attach an example of this function?