nagging display error in nx6

[onczy]

Can anyone give me advise me on the error " Error recovery completed for the following error: Internal error: memory access violation"

It happens over and over. I'm running nx6 64bit

 

[jelmerra]

The error message is not very descriptive. In the log file (help->NX log) there should be a more useful explanation of what went wrong. Scroll down and then up until where things went belly up.

 

[onczy]

Thanks, I wound up call UG and updated Graphic card and Drivers. Problem Solved.

Thanks for helping.

 

[suhaimie]

Dear All

Can any body help me with the below area.
I cannot open the file due to below error.

"EXCEPTION: INTERNAL ERROR in line 6478 of D:\ugnx30\sandbox\src\part\no\ind\part_load"

Thanks in advance.

 

[hudson888]

suhaimie,

What is that directory? Is it your installation directory or somewhere were you install the files. I suspect something is set to point to the wrong place but I can't tell what.

What version of NX are you running?



Best Regards

Hudson

www.jamb.com.au

Nil Desperandum illegitimi non carborundum