Superslinky
Automotive
Ok, so I want to be able to name the sheet in the Inventor browser and have the title block pull that name into the title. Any suggestion???
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Naming drawing sheets in Inventor?
- Thread starter Superslinky
- Start date
- Status
Sorry, it cannot be done (yet), at least according to ADesk's official response when I last submitted this request/question about one year ago.
No way to "dynamically" pull this field into the drawing.
I found a VBA workaround posted YEARS ago for a previous version if INV by (or at) either sDotson or CBliss, but that was a lengthy, messy solution.
The only "Sheet" properties currently available are: Sheet #, Revision & Size
RATHER STUPID, HUH?
No way to "dynamically" pull this field into the drawing.
I found a VBA workaround posted YEARS ago for a previous version if INV by (or at) either sDotson or CBliss, but that was a lengthy, messy solution.
The only "Sheet" properties currently available are: Sheet #, Revision & Size
RATHER STUPID, HUH?
- Status