BobWescott
Industrial
I am an experienced CAD/CAM programmer, but am just starting out with unigraphics, is there any training material available and what would be a good starter point.
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Tek-Tips community for having the most helpful posts in the forums last week. Way to Go!
Need a good training manual for UG begginer
- Thread starter BobWescott
- Start date
- Status
I am an experienced CAD/CAM programmer, but am just starting out with unigraphics, is there any training material available and what would be a good starter point.
JohnRBaker
Mechanical
Contact your local UGS sales rep and they can help set you up with severaql different options in self-paced learning.
John R. Baker, P.E.
Product 'Evangelist'
UGS NX Product Line
SIEMENS
UGS PLM Software
Cypress, CA
John R. Baker, P.E.
Product 'Evangelist'
UGS NX Product Line
SIEMENS
UGS PLM Software
Cypress, CA
If you are just looking for books, Design Visionaries books are very good. Check them out:
Mike
Mike
You can get on-line training at CAD CAM Assemblies Drafting and more.
- Status
Similar threads
- Locked
- Question
- Locked
- Question