JustAnotherBubba
Mechanical
Hi Everyone.
I am in need of a copy of the jig boring chart found in the Machinist's Handbook, entitled, "Lengths of Chords for Spacing Off the Circumferences of Circles with a Diameter Equal to 1." In my copy of the handbook, it is on page 991. I have used this chart so much that it is covered in machine grease, and isn't legible anymore. Any help would be greatly appreciated. )
Sincerely,
Donny a.k.a. JustAnotherBubba
I am in need of a copy of the jig boring chart found in the Machinist's Handbook, entitled, "Lengths of Chords for Spacing Off the Circumferences of Circles with a Diameter Equal to 1." In my copy of the handbook, it is on page 991. I have used this chart so much that it is covered in machine grease, and isn't legible anymore. Any help would be greatly appreciated. )
Sincerely,
Donny a.k.a. JustAnotherBubba