Need help cutting crs 0.040 with shop air 1

[gazousg]

Hi the machine is Amada Fo3015NT. we are not able to get a nice cut. Someone have cutting condition for this type of material?

 

[b20vtechb]

try using the cut condition for stainless steel of the same thickness, but change your assist gas to shop air.

 

[gazousg]

Thanks for your reply. I think we don't have a good air, cause we still have a lot of dross. not able to get a clean cut.

 

[RPosty]

if you can post a picture of the parts edge and of the cut condition screen, there are a few really good experts here who can help a lot if you provide enough information. I am not an expert, but things i would try is lowering air pressure, going up and down with focus, increasing and decreasing feedrate.

"I am stuck on Band-Aid brand, 'cause they are stuck on me"