Dec 8, 2005 #1 Stanfi Electrical Oct 11, 2004 71 0 0 US I am really new to fluid power. I have a delta 50/50 flow divider (HPR23). It has 2 inlet ports. One on each end. I was expecting only 1 inlet and 2 outlets. Do I need to Tee the inlets togehter, or can I just hook up one of them. TIA.
I am really new to fluid power. I have a delta 50/50 flow divider (HPR23). It has 2 inlet ports. One on each end. I was expecting only 1 inlet and 2 outlets. Do I need to Tee the inlets togehter, or can I just hook up one of them. TIA.
Dec 8, 2005 Thread starter #2 Stanfi Electrical Oct 11, 2004 71 0 0 US Ok, the answer I found was that I could tee the line from my valve and go into both inlets or I could plug one, and use only one inlet port. Upvote 0 Downvote
Ok, the answer I found was that I could tee the line from my valve and go into both inlets or I could plug one, and use only one inlet port.