Below are command from 2001 but I'm sure they're the same for 2000i & 2000i^2. I know they moved a lot of commands around with the new WF user interface.
To Insert Features
Normally, Pro/ENGINEER adds a new feature after the last existing feature in the part, including suppressed features. Insert mode allows you to add new features at any point in the feature sequence, other than before the base feature or after the last feature.
1. Choose Insert Mode from the FEAT menu, then choose Activate.
2. Select a feature after which the new features will be inserted. All features after the selected one will be automatically suppressed.
3. Choose Create and create the new features as usual.
4. Cancel insert mode in one of the following ways:
? Choose Resume from the FEAT menu and select to resume the features that were suppressed when you activated insert mode.
?
Choose Cancel from the INSERT MODE menu. Pro/ENGINEER asks you whether to resume the features that were suppressed when you activated insert mode, then automatically regenerates the part.
Note: The system grays out the Cancel and Activate options in the INSERT MODE menu in turn, depending on whether the insert mode is currently active. At any time, you can choose the Return option from the INSERT MODE menu to return to the previously active menu. If the feature after which the new features will be inserted is a merged-by-copy feature, the system redisplays the part to show only merged features. The INSERT FEAT menu appears with the options Create Copy and Mirror Geom. Once you choose Done from the INSERT FEAT menu, the system redisplays the whole part and exits Insert mode.
To Reorder Features
1. Use the command sequence Part, Feature, Reorder.
2. Specify the selection method by choosing an option from the SELECT FEAT menu:
? Select—Select features to reorder by picking on the screen and/or from the tree tool. You can also choose Sel By Menu to enter the feature number. When finished selecting, choose Done Sel.
? Layer—Select all features from a layer by selecting the layer. When you finish, choose Done Sel from the LAYER SEL menu.
? Range—Specify the range of features by entering the regeneration number of the starting and ending feature.
3. A system message lists the selected features for reorder and states the valid ranges for the new insertion point.
4. Choose Done from the SELECT FEAT menu.
5. Choose one of the options in the REORDER menu:
? Before—Insert the feature before the insertion point feature.
? After—Insert the feature after the insertion point feature.
6. Pick a feature indicating the insertion point, or choose Sel By Menu to enter the feature number.
Best Regards,
Heckler
Sr. Mechanical Engineer
SW2005 SP 2.0 & Pro/E 2001
Dell Precision 370
P4 3.6 GHz, 1GB RAM
XP Pro SP2.0
NIVIDA Quadro FX 1400
o
_`\(,_
(_)/ (_)
"There is no trouble so great or grave that cannot be much diminished by a nice cup of tea" Bernard-Paul Heroux
