Need help with a drawing

[plastercaster]

I have an assembly that I am trying to overlay a concept sketch on.

I made a drawing and sketched the concept on top of a cutaway view of the assembly. It looks good except the lines are not thick or highlighted, how can I get them to stand out a bit more?

 

[handleman]

Enable the "Line Format" toolbar. Select the sketch entities of interest and change their lineweight/style/color as desired.

-handleman, CSWP (The new, easy test)

 

[plastercaster]

thank you very much

 

[plastercaster]

Ok I have another problem, when I go to save the sketch as a pdf, it cuts the sides of the sketch off and forces the PDF into a letter sized page.

How can I get it to save as a PDF with a landscape sizing?