NEED TECH-TABEL FOR 1 IN A36 ON TRUMPF 6030

[scottyfireman]

IS THERE ANY ONE OUT THERE RUNNING A TRUMPF L6030 4000WATT THAT HAS A TECHTABLE FOR 1IN MILD STEEL AND HAVE HAD GOOD PROCESSING RESULTS WITH IT?? ALSO ARE LOOK FOR A TECHTABLE FOR PROCESSING WOOD ON THIS SAME MACHINE!!

 

[pclynx]

What software are you using? The software should be able
to supply that information.

 

[Co2Laser]

Scotty,

I run a L3030s 4K, and I use the following (copy and paste into your PLT4000.LST):

DA,'19917','TC8',4000,'ST-100',25.4,7.5,'2.300000',4,0.0,0.0,2.0
* ,2.032,2.032,0.5,100.0,1,1,0.508,4000,10000,0.6604
* ,1.016,1.0,3000,100,0.254,5.08,0.6,0.508,500,15
* ,0.0254,1.016,1.0,3000,100,0.254,5.08,0.6,0.508,500
* ,15,0.0254,1.016,1.0,3000,100,0.254,5.08,0.6,-8.0
* ,3.0,2,7.874,9.0,1,2.0,0,15.0,20,7.874
* ,9.0,1,0.5,0,2.54,0.0,38.1,200,10000,5.08
* ,2,2.0,-6.0,6.096,160,1000,2.54,1,2.0,-3.048
* ,3.048,140,1000,3.048,1,2.0,0.1,1,3.048,1
* ,2.0,-3.048,0.2,1,3.048,1,2.0,0.6,1,3.048
* ,1,2.0,100.0,2.5,2.5,2.5,3.0,3.9624,0,0
* ,0.0,0.0,0,0,0.0,0.0,0,0,0.0,0.0
* ,0,0,0.0,0.0,0,0,0.0,0.0,0,0
* ,0.0,0.0,0,0,0.0,0.0,0,0,0.0,0.0
* ,0,0,0.0,0.0,0,0,0.0,0.0,0,0
* ,0.0,0.0,0,0,0.0,0.0,0,0,0.0,0.0
* ,0,0,0.0,0.0,0,0.0,0.0


You owe me one!!!

 

[scottyfireman]

thanks this will be a big help!
also have you ever cut any wood on your machine??

 

[msandoval]

Co2Laser:

Would you be so kind to explain how that tech table works if it's not too much to ask?

thanks

msandoval