Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

new drafting sysmbols in NX10 that are not in ASME hoping for John Baker to reply

Thread starter Pockets4614
Start date Aug 13, 2015

Status: Not open for further replies.

Aug 13, 2015

Pockets4614

Aerospace

While being involved in pretesting of Siemens NX 10 CAD software before offically having the company
convert over to the newest NX 10 software, I have come across new symbols in the drafting symbol menu and GD&T symbol menu selections that I have never seen or heard of.
I am concerned about the following;
Axis Intersection
Approx Dimension
Insert Sphere
Left Pitch
Right Pitch
Left Taper
Right Taper
Any insight you could give would be appreciated very much. Thank-You for your time.