hoots711
Structural
- Jan 5, 2006
- 19
Happy New year all.
I have been instructed to convert some mathcad v11 documents to v8. (I think I was awarded this task simply becasue my machine has v11 installed)
New to mathcad, and I quickly found the save as (v8) option.
My simple question is: IS there a way to tell if the sheet had new options on it (that wouldnt convert backwards to v8)?
When I do a save as, I get a prompt saying "This may not work bla bla bla" but then just pops the form up.
Im looking to find out if the sheets are screwed up by going backwards to v8.
Any advice/direction?
I have been instructed to convert some mathcad v11 documents to v8. (I think I was awarded this task simply becasue my machine has v11 installed)
New to mathcad, and I quickly found the save as (v8) option.
My simple question is: IS there a way to tell if the sheet had new options on it (that wouldnt convert backwards to v8)?
When I do a save as, I get a prompt saying "This may not work bla bla bla" but then just pops the form up.
Im looking to find out if the sheets are screwed up by going backwards to v8.
Any advice/direction?
