wbd
Electrical
- May 17, 2001
- 659
Hello,
Apparently we have a situation where a documented switching procedure is required by 225.30(E). Does anyone have an example they could share? How detailed doe this have to be? Any insight would be appreciated.
I had posted this in the NFPA section but that was apparently not the correct forum so I am reposting it here.
Apparently we have a situation where a documented switching procedure is required by 225.30(E). Does anyone have an example they could share? How detailed doe this have to be? Any insight would be appreciated.
I had posted this in the NFPA section but that was apparently not the correct forum so I am reposting it here.