no i j k in g2 move 1

[rabbiddoggy]

Using postbuilder in NX10 to process and on some lines there are g2 moves without i or j and I tried different settings in post builder but cannot figure out why this is happening. Most lines have i and j but about 4 g2 lines dont and it messes everything up. What can be causing this?

 

[joycejo]

Is the missing value the same as the previous value?

You can Force to output from the motion event

John Joyce
Manufacturing Engineer
Senior Aerospace CT
NX 10 & 11.0.1 Vericut 8.0

 

[rabbiddoggy]

it might be, were do I find force output?

 

[joycejo]

I would highly recommend reviewing the Help Docs on Post Builder.

for example

https://docs.plm.automation.siemens.com/tdoc/nx/10.0.3/nx_help#uid:prog_toolpth_prog_circle_move

 

[Tingsryd]

Right clicking will bring up this menu.

10.0.3