Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations pierreick on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

non saturated steam 1

Status
Not open for further replies.

Nickel1011

Industrial
Feb 14, 2014
5
Hi guys,
I am having headache on an autoclave. The equipment is giving non saturated steam error. The temperature is monitored by two temperature sensors (Parallel), and usually the difference between the two sensor causes the problem. But now after calibration, the temperature are same. So still the same error.
 
Replies continue below

Recommended for you

You either have air in the steam that is causing the pressure to be higher than it should be with saturated steam, or you have superheated steam where the temperature is higher than it should be. My guess is that it is telling you to vent the air out of the autoclave.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor