Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NOx sensor signal correction

Status
Not open for further replies.

sheny14

Automotive
Dec 19, 2014
1
Hello ppl,

while running a NOx program at the engine test bench in a HD engine it was observed that the NOx values (ppm) before a NOx storage catalyst (NSC) was slightly less than NOx values after NSC(even after complete release of stored NOx). To find out any discrepancy relating to the sensors, measurement was done at the same location (before NSC) with two NOx sensors and observed variation in measurement values(differences ~ 5-10 ppm) at all time instances. Any suggestions on signal correction to arrive at a plausible value of stored NOx??

Thanks in advance.

Madhan
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor