Nozzle stiffness 1

[scalabres]

Hi all,

First of all, excuse me if this is not the correct forum where to post this thread, at least it has something to do with it.

I have to introduce a vessel's nozzle stiffness into the stress analysis software. I am using CAESAR II 4.50. I have radial displacement stiffness and longitudinal and circumferential rotational displacement stiffness. The problem is that I don't know how to model this in CAESAR. I have put a restraint X(1,1,1) type as the radial displacement restraint (with the given stiffness), but I don't know how to model the other two. In fact, is that assumption correct?

Advanced thanks

 

[JohnBreen]

Hello scalabres,

Thake your question directly to the COADE Caesar II discusion board:

http://www.coade.com/support_discussion.asp

You will find much specific ti Caesar II help there.

Regards, John.