Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX 11: Snapping to angled holes on a pipe

Status
Not open for further replies.

Huhu3

Mechanical
Jul 22, 2021
1
Hi,

I would like to know if there is a smart way to snap to angled holes on a pipe?
I have found a way to work around this by adding points in the right coordinates but if the positions of the holes are changed, the section line will not be updated.

Best regards,
Huhu

 
 https://files.engineering.com/getfile.aspx?folder=6facbcdc-6129-40e7-a50e-8ced7e329a9c&file=AngledHolesOnPipe.png
Replies continue below

Recommended for you

Is your problem that the section line does not stay associated to the hole on the drawing, if the hole is moved ?

Jerry J.
UGV5-NX1961
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor