NX has a 3D input devices settings command.
Mine is greyed out, even while in modeling.
I have the small 3DConnexion SpaceMouse. Does anybody has suggestions on how to "ungrey" it ?
If my memory serves me right, my friend had similar problem and he used older drivers for Space Mouse.
You can try, but no promises it will help.
(Second options - buy new Space Mouse )
Or ask somebody from 3dConnection?
1) make sure that you are running a driver that is supporting your device, i have recent experience that a "too new" driver did not work with a old spacemouse.- We downloaded a matching legacy driver from 3D connexion and it worked as expected again.
2) there are 3 windows variables setting where the 3dconnexion software is located, check that these contains "some files" ...
Regards,
Tomas
The more you know about a subject, the more you know how little you know about that subject.
I did reload the drivers, as mentioned, and after I did it I noticed something else.
Prior to that my 3D CONNEXION tab was not checked on.
You may verify it is on to make life easier for yourself.
Thanks for the replies.