NX 5 Toolbar Customization

[NXdesigner]

I am setting up custom tool bars for NX5. I currenly have a toolbar drop down that runs different macros to place specific rev blocks and flags on the drawing. For now these different rev blocks and flags are identified by a specific bitmap. These bitmaps are very hard to read at the smaller toolbar sizes. Is there a way to change from the bitmaps and just have a list of text drop down and be selected similiar to the menus?

Thanks!

 

[JohnRBaker]

Your best bet would be use Customize and define and then add to a new user-defined pull-down since if you do it there you can have both names and Icons displayed at once, as shown in the attached image.


John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

 

[DavidTolsma]

I would go the other way, and create a more unique image representing the action.

-Dave Tolsma
Tolsnet LLC

http://groups.google.com/group/NX_CAX/

http://groups.google.com/group/plm-exchange/