NX 7.5 Post Builder Problem 1

[ToigaT]

My Wire-EDM post processor suffers from a problem. When I try to post I get an error:
- - - - - - - - - - - - - - - - - - - - - - - -
***TCL_ERROR***: Event Handler: C:\Users\XX\Documents\XX\NX\Posts\CUT_30_13.tcl, Event: MOM_machine_mode, Error: can't read "sim_mtd_initialized": no such variable
while executing
"if { $sim_mtd_initialized } {
if { [llength [info commands PB_VNC_pass_tool_data] ] } {
PB_VNC_pass_tool_data
}
}"
(procedure "MOM_machine_mode" line 22)
"MOM_machine_mode"*** EXCEPTION: Error code 1770002 in line 475 of o:\ugnx75\ip32\src\camsmom\no\ind\mom_tcl_definitions.c at Tue May 18 08:35:23 2010
- - - - - - - - - - - - - - - - - - - - - - - -
To work around this problem, I have made an entry into the start of the program declaring sim_mtd_initialized as global and setting that to 0:

- - - - - - - - - - - - - - - - - - - - - - - -
global sim_mtd_initialized
set sim_mtd_initialized 0
- - - - - - - - - - - - - - - - - - - - - - - -

Please can someone advise me what is going wrong here. I am guessing there's a problem in the tcl definitions file.

 

[cadcamnx]

hi

you can send me the file for me to check
some custom comand was not created or loaded

awaiting

Andre

specialist and multi axis
development of IS & V
and postprocessors
member committee nxcam plm world
skype:andrenxcam7

 

[ToigaT]

I would just like to point out that I have just created a new post processor for Wire-EDM and I encounter the problem straight away. My previous posts also suffer from this problem if I update them via the 7.5 postbuilder.

 

[markrief]

This problem was already found and corrected, and a patch is available for an imediate fix. A field bulletin was issued last week with details. Please see SFB-NX-5324 "Patch for running Post Builder V7.5 and NX V7.5".


Mark Rief
Product Manager
Siemens PLM

 

[ToigaT]

Thanks Mark!