OK I called myself searching the forums but with no luck.
My NX 7.5 is not posting the correct feeds.
example:
M8
S500 M3
Z.1
G81 G99 Z-.195 R.1 F20.
X10.
The above feed should be F9. I have 9 as the feed in the operation.
And it is not just this operation. It is happening in others as well. I did not build either post we are using and I get the same result from both and as I dig further the generic 3 axis post that loaded with NX does the same thing. Anyone have an idea?
My NX 7.5 is not posting the correct feeds.
example:
M8
S500 M3
Z.1
G81 G99 Z-.195 R.1 F20.
X10.
The above feed should be F9. I have 9 as the feed in the operation.
And it is not just this operation. It is happening in others as well. I did not build either post we are using and I get the same result from both and as I dig further the generic 3 axis post that loaded with NX does the same thing. Anyone have an idea?