Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

[NX 8.5] Orient View to Face

Status
Not open for further replies.

justinheckman

Mechanical
Joined
Jun 27, 2011
Messages
16
Location
US
Hello All,

I'm looking for the command or workflow to orient the graphics window view to a specified face. I know snap-fit (F8) will orient the view to the coordinate planes, but I want to orient to an angled face, that isn't on a coordinate plane.

Is there a command for this?

Thanks

- Justin Heckman
 
Well that's simple enough!

Thanks again @cowski

- Justin Heckman
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top