nx 8 will not open any parts

[madcadjockey]

Nx 8 worked fine yesterday, this morning i get this error. An attempt was made to set a constrained attribute to a value outside its limits.

after that memory access violations on any part i attempt to open.

I can not open any parts.

Anyone have any ideas?

 

[cowski]

Update to the latest MR, if that doesn't work - contact GTAC.

www.nxjournaling.com

 

[looslib]

Reboot the workstation.
Run Ug_inspect on your part(s).


"Wildfires are dangerous, hard to control, and economically catastrophic."

Ben Loosli