NX Assembly - Component arrangement specific without any constraints?

[Mirza98]

NX2312

My components are all shown to be arrangement specific even though I deleted all of the constraints and there is only the default Arrangement 1. Under the position column, there is a yellow and a white circle and the tag "Unconstrained, arrangement specific".

When I checked the "Information" of the Arrangement, it told me that it was being used in a drawing exploded view. I deleted that drawing sheet but the issue still persists.

Thanks in advance.

 

[Mirza98]

Another thing, when viewing another assembly, under the arrangement info it says "There is an exploded view using this assembly arrangement: sequence explosion"

I deleted the sequence and this message is still there, how do I get rid of this sequence explosion?

 

[mmauldin]

Did you delete the explosions under Assemblies>Explosions?

 

[cowski]

I don't know if this directly applies to your situation, but you can make component positioning be arrangement specific even if there are no constraints involved. In the component properties -> parameters, the "individually positioned" option means the positioning is arrangement specific and "uses shared position" means the position is the same for all arrangements.

I don't have 2312 installed, but from what I've seen in other threads, the wording of the dialog seems to have changed. They may have also changed the default option, but I'm not sure about that.

www.nxjournaling.com