Shiv Raushan
Mechanical
Hello Eng Tips Community.
I am new to NX Journaling currently working to develop Journal for automation of section thickness measurement so that we can be sure that it is always greater than 50 mm in a Draw Punch. I have tried to generate codes by recording the sectioning process and then saving the Section curves and then measuring the deviation between curves.
I have been able to write codes for generating multiple section curves and then saving it, but am not able to go further ahead from that.
Can someone guide me for further?
Thanks in advance.
I am new to NX Journaling currently working to develop Journal for automation of section thickness measurement so that we can be sure that it is always greater than 50 mm in a Draw Punch. I have tried to generate codes by recording the sectioning process and then saving the Section curves and then measuring the deviation between curves.
I have been able to write codes for generating multiple section curves and then saving it, but am not able to go further ahead from that.
Can someone guide me for further?
Thanks in advance.