Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations SSS148 on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX mold wizard stock size

Thread starter jtrist
Start date Jul 24, 2018

Status: Not open for further replies.

Jul 24, 2018

jtrist

Automotive

Does anyone else have an issue with Mold Wizard stock size listing the diameter but changing the number to the radius? We have not been able to nail down when or why. It doesn't do it every time or every file, or even every part in the BOM of the same file. We use the same seed file for every part, so I dont think that is it either. Obviously its a big issue ordering the wrong stock if I don't catch it.

Thanks in advanced for any help.

Jim

Runnung NX 10.0.0.24
Not sure where to find the Mold Wizard version.