Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX1 error when opening

Thread starter crthorn
Start date Apr 25, 2007

Status: Not open for further replies.

Apr 25, 2007

crthorn

Computer

Thanks for all the past help, the members of this forum have been a great asset when troubleshooting UG.

I'm having trouble launching UG this morning. Nothings changed since yesterday but now I get the following message when I attempt to run the software.

ERROR HANDLING FAILED
"Run out of space whilst trying to allocate block of 1599034463 bytes"

Has anyone encountered this before? Any help would be appreciated.

Chris