Kenja824
Automotive
- Nov 5, 2014
- 950
Is there a way to close or suppress all common parts between to assemblies?
We will have a large assembly that we do our work to. Sometimes after a job is done, we will be given a new revision of the same assembly to update our work to. The new revision will have many of the parts still at the same revision and many that have been updated to new revisions. We need to go through the assemblies and compare them looking for the changes.
If there is a way to open both the assemblies completely, then close all common parts (part number & revision), leaving open only those that have been changed or added, that would make things a lot easier.
Is there a way to do this in NX?
If not, would someone have a journal that might do it?
Ken
My brain is like a sponge. A sopping wet sponge. When I use it, I seem to lose more than I soak in.
We will have a large assembly that we do our work to. Sometimes after a job is done, we will be given a new revision of the same assembly to update our work to. The new revision will have many of the parts still at the same revision and many that have been updated to new revisions. We need to go through the assemblies and compare them looking for the changes.
If there is a way to open both the assemblies completely, then close all common parts (part number & revision), leaving open only those that have been changed or added, that would make things a lot easier.
Is there a way to do this in NX?
If not, would someone have a journal that might do it?
Ken
My brain is like a sponge. A sopping wet sponge. When I use it, I seem to lose more than I soak in.
