NX1961 weight

[jerry1423]

I would like to take a simple weight of two bodies and I cannot do it. What is going on here ???
I have the filter set to SOLID BODY, go to ANALYSIS, and can only select solid faces. I am so dang pissed off.

I am getting quite frustrated at the new ways to do things in NX when the old ways were better.
I have a feeling all the good people retired and have been replaced by "know it all" clueless young people.

Jerry J.
UGV5-NX1961

 

[cowski]

Try using the "object set" option before selecting bodies.

If your filter is set to "solid body" and it lets you select faces, I'd suggest using "examine geometry" to see if there are any issues with the bodies.

www.nxjournaling.com