jerry1423
Mechanical
- Aug 19, 2005
- 3,428
I would like to take a simple weight of two bodies and I cannot do it. What is going on here ???
I have the filter set to SOLID BODY, go to ANALYSIS, and can only select solid faces. I am so dang pissed off.
I am getting quite frustrated at the new ways to do things in NX when the old ways were better.
I have a feeling all the good people retired and have been replaced by "know it all" clueless young people.
Jerry J.
UGV5-NX1961
I have the filter set to SOLID BODY, go to ANALYSIS, and can only select solid faces. I am so dang pissed off.
I am getting quite frustrated at the new ways to do things in NX when the old ways were better.
I have a feeling all the good people retired and have been replaced by "know it all" clueless young people.
Jerry J.
UGV5-NX1961