Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX2 Assembly Constraint Precision

Thread starter Drkwing
Start date Jul 26, 2005

Status: Not open for further replies.

Jul 26, 2005

Drkwing

Mechanical

There should be a parameter about the precision of the 3D constraints. Suppose there is an off-center value of 1E-6mm in any direction between a shaft and a hole. One can still mate these two bodies regardless of the minimal off-center value.

In Mechanical Desktop there was an assembly parameter for this. By adjusting it, the sensitivity of 3D constraints can be changed to desired value.

I wonder if there is such a parameter in UG NX2.

Best Regards