NX3 Plotter help

[nmiltner]

I am in need of help seting up my plotter. I have gone through and set up the printer, along with the paper sizes, alignment, etc. When I try to plot the top 1/4 inch of drawing is being cut off. I have my settings with no margins, and set up to print to an 11x17" page, and best fit to page. Also, my sheet size is 10.85" x 17", and my title block is 10.82 x 16.711. Any suggestios on how to get this to print the entire image? Thanks

 

[rg006]

It might work better if you use print to scale instead of best fit, and then just make sure your sheet size matches your paper size. If your are printing a scaled down version of the plot view, we found it better/easier/always done it that way, to set the plotter to "print to file", and then print the new file. We keep all prints on a server, so this was better for us.
Hope this helps,
Rick

 

[nmiltner]

Thanks.
That worked along with playing arounw with the shifting in the vertical and horizontal a little bit.