Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations IDS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX3 Routing Defaults

Thread starter RRdesigner
Start date Jun 29, 2006

Status: Not open for further replies.

Jun 29, 2006

RRdesigner

Mechanical

We are using NX3 and Routing Mechanical. I have managed to adjust almost all preference setting for start-up. But one setting is missing. That is: How to set the default discipline ? The default discipline seems to be Piping, but we are using only Tubing. This preference can be changed from Routing Preferences and from tab Disciplines. But that has to be done every time in one session. That's quite frustrating.