NX4 with Windows 7 32-bit: Post Processor not working

[deacons323]

Hi all,

I've got NX4 installed on a Windows 7 32-bit machine... when I initiate Post Processor on NX a command screen opens real quick and then closes. I'm dead in the water and hoping one of you can help. Much appreciated

 

[JohnRBaker]

You would be better served if you posted this in the Siemens: UG/NX forum.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.com/museum/

To an Engineer, the glass is twice as big as it needs to be.

 

[deacons323]

Can you give me a link to the discussion forum please.. I'm having difficulty locating.

 

[deacons323]

Disregard... located, thx