Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX5 Advanced Sim: repeatable bug in postprocessing (stop animation)

Status
Not open for further replies.

potrero

Mechanical
Joined
Aug 30, 2007
Messages
516
Location
US
NX 5.0.5 Advanced Simulation

If one is generating an animation, say, of a transient simulation (option: Animate-Iterations), and you Stop the generation of the animation before it is done, NX will pop up a window informing you that the operation has been aborted as requested, then dump you out to the simulation window, but without geometry visible. Entering the FEM file doesn't make the geometry visible. What seems to work is to enter the part file and enter Modeling, then go back to the Sim file. But this is probably not the most desired behavior - after all, the intent to Stop generating an animation is probably to get back to work, or fix something...
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top