NXdesigner
Aerospace
Is it possible to change the order the columns in the expression editor for NX5? Ex: move "comments" to the left of "type"
Eng-Tips is the largest engineering community on the Internet
Intelligent Work Forums for Engineering Professionals
-
Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
NX5 Expression Editor
- Thread starter NXdesigner
- Start date
- Status
JohnRBaker
Mechanical
It would also be nice to take out the columns that you do not need.
That's easy, just drag the boundaries between the columns until they're full collapsed as you would do in Excel and as seen in the attached AVI.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
That's easy, just drag the boundaries between the columns until they're full collapsed as you would do in Excel and as seen in the attached AVI.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
NXinstructor
Industrial
John-
Thanks of the avi. My question is if you collapse those columns, is there any way for a user, who is not familiar with your file, to recogonize that those columns are collapsed? It would be nice if we could customize those columns just like the toolbars or the Assembly Navigator.
Thanks of the avi. My question is if you collapse those columns, is there any way for a user, who is not familiar with your file, to recogonize that those columns are collapsed? It would be nice if we could customize those columns just like the toolbars or the Assembly Navigator.
JohnRBaker
Mechanical
No, they behave just like collapsed columns in Excel.
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA
- Status
Similar threads
- Locked
- Question
- Locked
- Question