NX5 Point ID on Drawing

[sinico]

Dear Sirs!

I´ve created a hole table (x,y,z) through a grip (I used the default one from the grip library) on my drafting drawing. The table identify the hole, the coords and all but now, I need to ID the holes manually on the drawing... cause the grip only do the table for me... is there any other grip/way to do that automatically for me?

Thanks a lot!
Fernando

 

[jerry1423]

There must be a way to do this, but it will take some thought.
I will try to get back to you on this.

 

[JohnRBaker]

Install NX 6, it has a Hole Table function built-in to the Drafting module which does just exactly what you want.

John R. Baker, P.E.
Product 'Evangelist'
NX Design
Siemens PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.