nx5 sketcher change line to reference line?

[gordo56]

how to change line to reference line in sketcher??.

 

[PDW]

Find the command: Convert to/From Reference

This should do the thing you want.

 

[Jaydenn]

Pick the lines you want reference with left mouse button, then right click the selection and choose "convert to/from reference"

Works for curves and dimensions.

J

NX 6.0.5.3

 

[PDW]

Hi Jaydenn,

Thanks for this Tip, that is what this Forum is about share some Helpful tips and this was one I can appreciate!



Best regards,

Pascal,

NX5.04+TC2007 (GM Toolkit) / NX7.5 native

 

[SiW979]

Right mouse button is pretty powerful in NX, right clicking on many things will pop up a menu with filtered/associated tasks/commands e.g.

Right click on an edge and the top two options will be chamfer and edge blend, right click on a sketch in modelling and you get extrude and revolve etc etc.

Best regards

Simon NX4.0.4.2 MP10 - TCEng 9.1.3.6.c - (NX7.5 native)

http://www.jcb.com

Life shouldn't be measured by the number of breaths you take, but by the number of times when it's taken away...