Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations SDETERS on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

NX6, 5 axis post TNC 530

Status
Not open for further replies.

moog2

Mechanical
Jan 16, 2007
441
does anyone have a comversational Heidenhain iTNC 530 , 5- axis Mill, post processor for NX6, they could share with me?
 
Replies continue below

Recommended for you

My Heidenhain back ground is that the conversational was for shop floor and included a flex programming opition, which allowed various ways to program. However, we did develope a post which was Unigraphics (EIA/ISO) dependent. However, its been eons and I doubt that much would match. The machine also included a digitizing probe, but was limited in memory storage, if I recall right.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor