NX6, 5 axis post TNC 530

[moog2]

does anyone have a comversational Heidenhain iTNC 530 , 5- axis Mill, post processor for NX6, they could share with me?

 

[highspeedmachinist]

My Heidenhain back ground is that the conversational was for shop floor and included a flex programming opition, which allowed various ways to program. However, we did develope a post which was Unigraphics (EIA/ISO) dependent. However, its been eons and I doubt that much would match. The machine also included a digitizing probe, but was limited in memory storage, if I recall right.