NX6 open part display 1

[jerry1423]

When I close a part file in NX6 I get the NX Tips display.

I believe there is a toggle someplace that allows another open part to be immediately displayed when one is closed, but I have no idea where that toggle is.

I do not mind getting the NX Tips display when there are no other open parts, but can someone tell me where the toggle is that will display another part?

 

[cowski]

Look in the customer defaults Gateway -> General -> 'Part' tab, then scroll all the way to the bottom. Check the option 'change display part on close'.

 

[cowski]

Look in the customer defaults Gateway -> General -> 'Part' tab, then scroll all the way to the bottom. Check the option 'change display part on close'.

Change will take effect next time you start NX.

 

[man2007]

Is this option available in NX4 also?

 

[JohnRBaker]

Sorry, but that option was first introduced with NX 5.0.

John R. Baker, P.E.
Product 'Evangelist'
Product Design Solutions
Siemens PLM Software Inc.
Industry Sector
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

To an Engineer, the glass is twice as big as it needs to be.